- Help Centre
- Devices + Accessories
- Drum accessories and other equipment
-
Automotive
-
Spray & Cleaner
-
Construction & Forestry
-
Industry
- Gear oils industry
- Slideway oils
- Hydraulic oils
- Vacuum pump oils
- Compressor oils
- Various oils industry
- Turbine oils
- Cylinder oils
- Heat transfer oils SYNT
- Spindle fluids
- Greases
- Pastes
- Special greases
- Silicone greases
- Actuating agents Cooling lubricants
- Cooling lubricants
- Defoamer Cooling lubricants
- Cutting oils
- Thread Cutting Oils & Pastes
- Punching oils
- Fast evaporating punching oils
- Hardening oils
- Minimum Quantity Lubrication Off
- Drawing and forming oils
- Grinding oils
- Lapping and honing oils
- Erosion oils
- Silicone oils
- Forming pastes
- Die lubricant
- Special products
- Mould release agent
-
H1 FOOD
-
VIRO-PROTECT
-
Devices + Accessories
Spray Can WSD 400 WEICON 400ml
Art.-No. 955086
Description
WSD 400 is a refillable spray can with which most WEICON liquid active substances can be processed. It is filled with compressed air by means of an adapter (accessory) via the compressed air network (optimum operating pressure 7.5 bar).
The range of accessories for the WSD 400 includes an adapter for filling on any compressed air system as well as a spray set with four different spray heads and a ball valve with suction pipe.
Application
Before refilling with active ingredient, allow residual air to escape; then unscrew union nut and pull out spray valve. Hold can vertically and fill to max. 2/3 (approx. 400 ml). Insert spray valve and close union nut by hand. Fill with compressed air (min. 5 - max.10 bar). If different fillers are used, clean the container. After filling, only tighten the union nut by hand! In case of frequent use, check the seal in the closure. Do not fill with liquids which are alkaline or which decompose plastics. Do not use corrosive or toxic gases, vapors or liquids.